Details of multiple socket outlet with filter FNL10



Detailed view of multiple socket outlet with filter FNL10 Detailed view sockets: Here you can clearly see the marking dots for the mains-phase. A connection of the socket outlet at the wall with two bolt is possible.
Detailed inside view of multiple socket outlet with filter FNL10 Construction: The internal wiring of phase and ground is accomplished by 2,5 mm² - brass -massive rails and is designed in contrast to bulk-good end-to-end. Thus contact-resistance with voltage-drops and hum can be avoided. The socket-outlet has a switch, the connected cord is 2m long and consists of wires with 2,5mm² cross-section. The permanent power load is 16 Ampères or 3600 Watts. In the photo you can see the blue ferrite-ring which is wrapped by the mains wires. The robust mains plug has a hole for taking the protection-earth-pin which is placed is the outlets of some countries.
Detailed inside view of multiple socket outlet with filter FNL10 Detailed view inside: Here you can see the massive current rails. Contact between the Copper-wires of the connected mains-cord and the current-rails is done by silvered conductor sleeves.
Picture of construction mains-cord Construction mains-cord: Standard length is 2 meters. Pure Copper wires, cross-section of 3 x 2,5 mm² with very low loss, transparent outside insulation above a dense shielding of tinned Copper.
Picture of angle-mains-plug (option) Angle-mains-plug: This version can be taken for example if there is only few space between the wall-outlet and a closet. The additional price is only EUR 8,-


Back